20W vs 30W Charger
Is 30W worth the extra dollars over 20W? We benched both against five common devices at 25 °C and measured the wall-clock difference. Short answer: for iPhones, 20W is the whole story; for Android PPS phones and iPads, 30W is not optional.
The measured difference on an iPhone
iPhone wired charging tops out around 20–27W depending on generation, and the last watts taper hard above 50% battery. On an iPhone 16, a 20W charger and a 30W charger landed 0–50% within 2 minutes of each other — the phone simply doesn't request more. If your household is iPhone-only, a 20W brick loses nothing. This is the single most expensive misconception in phone charging.
Where 30W pulls clearly ahead
Samsung Galaxy phones with PPS fast charge, Google Pixels, and iPads all request 25–35W at peak. On those devices the 20W charger became the bottleneck in our bench: Galaxy S25 0–50% took 31 minutes at 20W versus 21 minutes at 30W PPS — a third of the waiting gone. iPad Air dropped from 95 to 68 minutes. The 30W premium pays for itself the first month if any of these devices share your desk.
PPS: the protocol detail that hides inside '30W'
Samsung and Pixel fast charge ride on PPS — Programmable Power Supply — which adjusts voltage in fine steps. A '30W' charger without PPS falls back to 15–18W on those phones. Check the spec for 'PD 3.0 PPS', not just wattage. Every 1edo charger at 30W and above implements PPS; we list the protocol explicitly on each product page.
Heat and headroom
A right-sized 30W GaN charger runs cooler than a maxed-out 20W unit pushing a PPS phone, because it operates below its ceiling instead of pinned at it. Heat is what throttles speed mid-charge — our thermal runs at 25 °C show the 30W unit holding its rated output through the full 0–50% window while a stressed 20W unit stepped down.
The decision rule
iPhone-only household → 20W, spend the savings on a second cable. Any Samsung/Pixel/iPad in the mix → 30W PPS, non-negotiable. Mixed or future-proofing → 30W costs little and covers both worlds. And when a laptop joins the desk, that's a 65W conversation entirely.
How we ran the test
Method matters in charging comparisons, so here's ours in full: same wall circuit, ambient held at 25 °C, the same 5A E-marker cable for every run, devices at 5% starting charge and screen-off, n=3 units per charger and n=3 devices per model — then averaged. Charging speed varies run-to-run with battery temperature, so single-run reviews mislead; our numbers are medians with the spread inside one minute. Replicate it at home with any wattage meter and you'll land within a few percent of our table.
When even 30W isn't the answer
Two cases where the 30W upgrade still won't help. First, phones standing in a hot car or under a pillow: heat throttles the charge rate below what even a 20W brick can deliver — move the device before buying more watts. Second, 'topping up' from 80% to 100%, where every phone tapers to single-digit watts regardless of the charger. The 30W premium buys speed in the 0–50% window only, which is exactly the window that matters when you're rushing out the door.
Bench results at 25 °C, reference cables, n=3 devices each
| Device | 0–50% @ 20W | 0–50% @ 30W PPS |
|---|---|---|
| iPhone 16 | 29 min | 27 min |
| Galaxy S25 | 31 min | 21 min |
| Pixel 10 | 34 min | 24 min |
| iPad Air 13 | 95 min | 68 min |